Results: Airlow w/o obstacles
Sometimes they don’t even get a chance and are immediately replaced by other, “better” ones. We’re talking about fans that come pre-installed in computer cases. We are going to test one of them now and although there are reasons to replace the Dynamic X2 GP-12 (PWM), be careful not to end up being worse off. After all, these aren’t exactly ordinary fans. They even have more specific aerodynamics and acoustics modifying features.
Results: Airlow w/o obstacles
Why is there a missing value sometimes? There may be more reasons. Usually it is because the fan could not be adjusted to the target noise level. Some have a higher minimum speed (or the speed is low, but the motor is too noisy) or it is a slower fan that will not reach the higher decibels. But the results in the graphs are also missing if the rotor is brushing against the nylon filter mesh. In that case, we evaluate this combination as incompatible. And zero in the graphs is naturally also in situations where we measure 0.00. This is a common occurrence at extremely low speeds with obstructions or within vibration measurements.
Continue: Results: Airflow through a nylon filter
- Contents
- Fractal Design Dynamic X2 GP-12 PWM in detail
- The basis of the methodology, the wind tunnel
- Mounting and vibration measurement
- Initial warm-up and speed recording
- Base 7 equal noise levels…
- .. and sound color (frequency characteristic)
- Static pressure measurement…
- … and airflow
- Everything changes with obstacles
- How we measure power draw and motor power
- Measuring the intensity (and power draw) of lighting
- Results: Speed
- Results: Airlow w/o obstacles
- Results: Airflow through a nylon filter
- Results: Airflow through a plastic filter
- Results: Airflow through a hexagonal grille
- Results: Airflow through a thinner radiator
- Results: Airflow through a thicker radiator
- Results: Static pressure w/o obstacles
- Results: Static pressure through a nylon filter
- Results: Static pressure through a plastic filter
- Results: Static pressure through a hexagonal grille
- Results: Static pressure through a thinner radiator
- Results: Static pressure through a thicker radiator
- Results: Static pressure, efficiency by orientation
- Reality vs. specifications
- Results: Frequency response of sound w/o obstacles
- Results: Frequency response of sound with a dust filter
- Results: Frequency response of sound with a hexagonal grille
- Results: Frequency response of sound with a radiator
- Results: Vibration, in total (3D vector length)
- Results: Vibration, X-axis
- Results: Vibration, Y-axis
- Results: Vibration, Z-axis
- Results: Power draw (and motor power)
- Results: Cooling performance per watt, airflow
- Results: Cooling performance per watt, static pressure
- Airflow per euro
- Static pressure per euro
- Results: Lighting – LED luminance and power draw
- Results: LED to motor power draw ratio
- Evaluation
I’m wondering how reviewed fans relate to 140mm version, Dynamic X2 GP-14.
I have three of them mounted as stock fans in Fractal Design Meshify 2 case and 3x Fluctus 120 PWM in drawer.
GP-12 are clearly inferior to Fluctus, but what about 140mm GP-14 vs 120mm Fluctus when used as 2x intake and 1x exhaust case fan?
Sooner or later we will get to such a comment. Anyway, these are structurally completely different designs, where the Fluctus 120 PWM is handicapped by higher tonal peaks at lower frequencies and with the Dynamic X2 GP-14 it might be again (like the Dynamic X2 GP-12 PWM) a relatively noisier, gently whirring motor. We’ll see…