DeepCool FC120: Big ARGB blades in a “small” cross-section

Results: Speed

The biggest advantage, but at the same time the biggest disadvantage of the DeepCool FC120 fan are its long and overall large blades, whose area exceeds that of competing models. Among illuminated fans, this one represents one of the most efficient solutions with ARGB LEDs, in optimal conditions. However, it is important to notice its downsides, which are a side effect of the chosen rotor design.

Results: Speed

Note: The stated speeds are measured in a non-restrictive, obstacle-free environment. With obstacles present, the fans will be slowed down. The degree will vary fan to fan but the achieved speeds will simply be slightly different. They are lower mostly in modes normalized by different noise levels.









Why is there a missing value sometimes? There may be more reasons. Usually it is because the fan could not be adjusted to the target noise level. Some have a higher minimum speed (or the speed is low, but the motor is too noisy) or it is a slower fan that will not reach the higher decibels. But the results in the graphs are also missing if the rotor is brushing against the nylon filter mesh. In that case, we evaluate this combination as incompatible. And zero in the graphs is naturally also in situations where we measure 0.00. This is a common occurrence at extremely low speeds with obstructions or within vibration measurements.


  •  
  •  
  •  
Flattr this!

Leave a Reply

Your email address will not be published. Required fields are marked *