Noctua NH-D15: Austrian dual tower

Test procedures

We extended our database of processor coolers with the notorious NH-D15. It will serve as a key reference point for every upcoming test because it represents some kind of a standard for air coolers. In this review, we analyzed the functional features of the most popular product in its category. How does Noctua do it?

Test procedures

Tests begin with the analysis of fans. Using the Gophert CPS-3205 II laboratory power supply and the UNI-T UT372 laser tachometer, we detected the initial speed. That means determining the minimum voltage required to move the rotor in the idle stage. Subsequently, we regulated the revolutions by hundreds (from 400 rpm to the round maximum), which gave us the first part of the data to create a curve that indicates the noise increase according to rpm. To make the results as accurate as possible we took the average values of 30 seconds long sequences and regulated the fans by the hundredths of volt until the tachometer reached a specific value, for example 800 rpm. Finally, we noted down the maximum rpm and put values into the parameters table.

   

To assign a specific noise level to a specific speed, we put the coolers with corresponding voltages to the soundproof box in which we measured the noise. This was done using the Reed R8080 sound level meter that was recalibrated before each set of measurements. The positions of the polyethylene pad on which the coolers were fixed, and the sound level meter were always the same. To achieve the most precise logging even with the lowest flow the distance between the sensor of the meter and the fan was approximately 25 cm. Each measurement was performed in real time. The meter sent 30 sound samples to the computer, from which we took the average value and put it into the charts. The most important part was to find and to align the fan settings to fixed noise levels. In this case, 45, 42, 39, 36, 33, and 31 dBA were selected, and with the exception of the last and the penultimate mode, each further decrease of rpm reduced the noise level by a half. On the one side there was noisy 45 dBA and on the other almost completely silent 31 dBA.

If one of the modes is missing in the charts, it is either due to insufficient cooling performance or because it was not possible to regulate the fan to the desired noise level. Each test lasted 600 seconds. We simulated the burn in IntelBurnTest (7500 MB) and the result represents the average of maximum temperatures of CPU cores, which were captured in Core Temp. At the time when some of the cores reached 95 °C, the tests were interrupted and considered unsuccessful.

Cooling performance tests were done in our plexiglass wind tunnel with a motherboard in the vertical position, just like in a usual tower case. The scheme of the system cooling was traditional, balanced flow was provided by four Noctua NF-A12S PWM fans. Two were at the input and two at the output, regulated to 550 rpm.

The intake air temperature was 21 – 21.3 °C, ensured in our air-conditioned lab so we could also accurately measure the automatic regulation PWM. Only during this process we put the processor with TDP 140 W back to the factory settings. The curve of the profile of the impulse modulation was set, regarding to low noise level, to 20 % ≤ 20 °C – 30 % ≤ 40 °C – 40 % ≤ 60 °C – 100 % ≤ 90 °C.


*Without overclocking, the power consumption of the configuration during IntelBurnTest load was around 170 W; 225 W with overclocking (approximately 180 watts by processor).


  •  
  •  
  •  
Flattr this!

Arctic Freezer 36 A-RGB – In the spirit of bold innovation

The German company Arctic celebrates 23 years of its founding this year and to mark the occasion, new Liquid Freezer III AIO coolers were recently introduced. Today also sees the launch of new Arctic Freezer 36 air coolers. These coolers come with a number of bold innovations and one of them has led to some changes to the format of today’s review. Today, we’re going to take a look at the top model in this series with the A-RGB Black moniker. Read more “Arctic Freezer 36 A-RGB – In the spirit of bold innovation” »

  •  
  •  
  •  

New Liquid Freezer (III): Better contact and compressor from a plane

Arctic says that historically, it can’t recall a product receiving more user interest right out of the gate, just after release, than the Liquid Freezer III coolers. But no wonder. In addition to efficient fans, they bring several features to enhance cooling performance. The latter is not only high, but also very affordable. Arctic has put the coolers on sale with a rather large, still ongoing discount. A 360-millimeter variant for under 80 euros? Read more “New Liquid Freezer (III): Better contact and compressor from a plane” »

  •  
  •  
  •  

BeQuiet! Dark Rock Elite – The new king of coolers?

I will start this year’s cooler tests with a real treat. I’ve prepared a review of the Dark Rock Elite cooler, the absolute top of BeQuiet!’s range. This is a premium cooler offering very high performance at low noise levels thanks to its sophisticated design in combination with high-end fans. I’m very curious to see how it performs compared to the high-end coolers I’ve had the opportunity to test over the past year. Read more “BeQuiet! Dark Rock Elite – The new king of coolers?” »

  •  
  •  
  •  

Leave a Reply

Your email address will not be published. Required fields are marked *