DeepCool LT720 – Solid cooler with a gorgeous block

The LT720 cooler is the top of the range from DeepCool. It is a classic 360mm liquid all-in-one cooler that should offer an interesting price/performance ratio. At first glance, it will catch your eye with its visual design that combines simple geometry and a mirror effect with RGB backlighting. Above all, however, coolers should perform well without being too noisy. So let’s see how well the LT720 does in our tests.

Measurement methodology

As a test processor and heat generator, I am now using an Intel Core i7-11700K on the Asus TUF Gaming Z590-Plus WiFi motherboard. The entire build is mounted on a Streacom BC1 frame with no fans to provide airflow. Acoustic shielding (acoustic foam on OSB boards) is installed around the test setup to eliminate ambient noise.

   

The Voltcraft SL-100 calibrated noise meter is placed perpendicular to the cooler in a fixed position relative to the motherboard at a distance of approximately 35 cm from the processor socket. Stress tests are performed using Prime95 with a duration of 30–35 minutes. The coolers are tested at three standardized noise levels (36, 39 and 42 dBA) and finally at maximum speed. The tests are run in two sets according to the heat output of the processor.

The first set of tests is at 125 W, the PL1 processor’s enforced limit. The second set of power draw is then about 205–210 W (4500 MHz at 1.285 V). However, this second level represents a very high concentration of heat per mm² due to the small size of the chip itself. Thus, not all coolers can be expected to pass this set of tests at all noise levels. At the end of the test, the highest temperature achieved is always recorded.

All data regarding CPU temperatures and heat output are obtained from the HWiNFO64 application. The measured values are then corrected against the room temperature as the resulting Delta T value. Any higher value means a processor temperature over 95–100 °C and a risk of thermal throttling. Therefore, if the cooler does not pass the load with a Delta T value below 75 °C, such a test is marked as a failure.


Cooling Topics at HWCooling Techtour ‘26 Belonged to DeepCool

Do you know how a heatpipe works? A DeepCool representative, in a talk at HWCooling Techtour ‘26, looked under the hood. In other words, he explained much of what often remains hidden. This included how they approach development and what they work on internally. That, too, was part of the program, which you can watch. The physical samples, which were also on display, come only at the very end of the whole journey. Read more “Cooling Topics at HWCooling Techtour ‘26 Belonged to DeepCool” »

How a CPU Cooler Works. Intended for Secondary Schools

The purpose of a CPU cooler is to transfer enough heat away from the processor so that it can operate within its optimal parameters, for example clock speeds. These are only achieved within the expected range if the processor, in combination with the cooler being used, does not heat up more than is desirable for achieving attractive performance. Yes, everything usually revolves around speed, but that is also associated with factors such as power consumption. Read more “How a CPU Cooler Works. Intended for Secondary Schools” »

Computex 2026: New Hardware Outside the Main Spotlight

Computex is not just for the industry giants. Alongside major manufacturers, smaller brands regularly showcase unconventional designs and innovative engineering to capture attention. Some of these concepts prove to be developmental dead ends, while others pioneer features that later integrate into mainstream products. Even if not every innovation succeeds, many certainly deserve recognition. Read more “Computex 2026: New Hardware Outside the Main Spotlight” »

Leave a Reply

Your email address will not be published. Required fields are marked *